Power distribution vs terminal block what's the difference - Model Railroader Magazine

• Member since
  December 2010
• From: The place where I come from is a small town. They think so small, they use small words.
• 1,141 posts

I use the terminal strips to connect my drop feeders (thin, phone guage wire), to my bus wires (something like 16-18 guage).  At some point, even though I will switch to DCC, I will install a control panel with DPDT (center off) toggle switches to be able to disconnect certain tracks, set up a programming track, and to be able to use DC for locos that have not had decoders installed.  Eventually, I plan to decoderize every loco, but with over 70 on the roster, that may take a while.  Anyway, I made a couple of "daisy chains" under the layout using crimp on spade connectors, the ones where you can loosen the screw and slip them in, and tighten the screw.  I simply installed 2 wires on each one before crimping (except the last one on a terminal strip).  I'd post a picture, but I need a new battery for my camera.

Brad 

EMD - Every Model Different

ALCO - Always Leaking Coolant and Oil

CSX - Coal Spilling eXperts